We have an issue with a box trying to reach the subnet on my dmz which is 192.168.50.0, everything else inside can reach it fine except 2 servers, we have 2 routers using vrrp, 1 of them being active for routing to the dmz via a vlan. before I was here the other guy put a static route on the servers pointing to one of the routers instead of the alias, when I take the static route off the server and let it use the alias, it starts dropping packets, but just from these 2 servers and nothing else, what should I check on this ?
Some HP servers don't work correctly with VRRP for whatever reason, and some others don't as well.
The issue is with the fact that there are technically two mac addresses for the gateway possible when everything is in an operation state - the virtual, and the physical mac address of the device. Has a lot to do with the 2 address model.
For whatever reason, some devices have trouble with that.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...