Using SDM, I have managed to create a vpn server. Connecting users are assigned IP addresses from the range 192.168.3.0/24.
All my other computers are located in VLAN4 and have IP addresses in the range of 192.168.0.0/24.
I would like the VPN users to access all data in the 192.168.0.0 network.
Now for my question: I tried pinging a server in the .0.0 network, and it actually replied. I then tried to establish a connection with the windows share located on that server which failed (with no useful error message).
Now I am wondering: Am I missing something? Will I need to enable routing for these two networks?
I cannot perform your solution as I have no interface for the vpn users. There exists only a pool of IP adresses which are assigned to users dialing in. So basically there is only the outside interface with our public IP address and the internal Vlan where most of our users are.
Did I forget something when configuring the device? Would I need to add ip helper-address to the outside interface (sounds odd to me)?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.