Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Routing past VPN client

Hi Guys,

I need some serious help again. Im testing a way to route after a client.

I could try explain this for 3 pages, but this drawing should make it easier to understand.

Ping from 10.5.0.1 to 10.4.0.1 (Green line) Works!

Ping from 10.5.0.1 to 172.17.0.1 or 172.17.0.2 (Red line) DOES NOT WORK.

SetupTest.gif

Im using the Windows XP desktop with 2 network cards as a router.


I have included the config of the Cisco Router below.

If anything else is needed or needs clarification please ask.

I dont really understand why it doesnt work.

One last note: I CAN ping 172.17.0.2 from the Cisco Router!, so i think it should work from 10.5.0.1 aswell but it doesnt.

Can anyone help?

Everyone's tags (6)
1 REPLY
New Member

Re: Routing past VPN client

Hello, you have enter the command "reverse-route" in the crypto map.

crypto dynamic-map customerHQmap 1
set transform-set security

reverse-route
!
crypto dynamic-map customermap 1
set transform-set security

reverse-route
!

689
Views
0
Helpful
1
Replies
CreatePlease to create content