cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
371
Views
0
Helpful
1
Replies

Routing problem to single ip address

mshickell
Level 1
Level 1

Got a very strange routing problem. Had a fault come in that a voice server was inreachable (10.102.6.2). A traceroute seemed to see 10.102.254.17 as the second hop and all subsequent hops as well! This address is the exit interface of a 3845 router (first hop was the WAN address of this router). 10.102.0.0/16 is forwarded to a firewall on the directly connected subnet 10.102.254.0/28.

Funny thing is that trace to the IP address 10.102.6.3 routes ok and tracing to 10.102.6.2 on the 3845 gives it's own ip address as the first hop!

Very odd and am currently suspecting an IOS fault. Change control is a nightmare so am exhausting all other options first.

3845#sh ip arp | in 10.102.254.18

Internet 10.102.254.18 203 0023.336b.0000 ARPA GigabitEthernet0/1.16

3845#sh ip route 10.102.6.2

Routing entry for 10.102.0.0/16

Known via "static", distance 1, metric 0

Redistributing via eigrp 110

Advertised by eigrp 110

Routing Descriptor Blocks:

* 10.102.254.18

Route metric is 0, traffic share count is 1

3845#trace 10.102.6.2

Type escape sequence to abort.

Tracing the route to 10.102.6.2

1 10.102.254.17 0 msec 0 msec 4 msec

2 * * *

3 * * *

4

1 Reply 1

Richard Burts
Hall of Fame
Hall of Fame

Mark

The show ip route indicates that the destination is learned via static route. Can you post the route from the config? Can you also post the output of show cdp neighbor detail?

HTH

Rick

HTH

Rick
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: