I have the following topology: coresw>distributionsw>accesssw1>PtP WAP Bridge>accesssw2>router
VLAN300 is setup on the coresw and popultaes across to accesssw2 and i am able to ping DGW vlan 300 from every device on the network accept the router, this router is on vlan 300 and is connected to accesssw2 on a vlan300 port, i have the DGW for vlan300 defined on the router as well.
I know this is something with topolgy but can't figure it out.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...