I have a PIX506E as the firewall between my LAN and my ISP. The power supply failed and while waiting for a replacement, I replaced the PIX with a Netgear router. This worked for what I needed (Internet access for browsing and email). When I went back to the PIX all desktops and servers are able to access the Internet as before except one server, my Exchange Server. No email in or out. Browser says page not found. I can ping the Pix and login to the PIX configuration. I cannot ping DNS server (outside). The gateway address, LAN mask, and DNS addresses are correct on the server. The MAC address is correct for the PIX IP address in the ARP table. The PIX configuration seems to be the same as it was before (although not 100% certain). I have rebooted the server. Ths is a Windows NT 4.0 server. I can return to the Netgear router and it works.
Can anyone think of something else to try to resolve this problem?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...