Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Routing to EHWIC Network Module VLAN on 2901

I am able to ping from router 1 to router 2 connected by GE0/0 ports on both sides. I am also able to ping to the vlan interface ip address set up for all ports on the network module. I can ping from router 2 to the host just fine. I know I'm missing something to route from the GE0/0 port on router 2 to the vlan, but not sure what it is. So far for routing I have: ROUTER 1 router rip version 2 network 192.168.1.0 (this is the GE0/0 network) neighbor 192.168.1.2 (this is router 2 GE interface) ROUTER 2 router rip version 2 network 192.168.10.0 (this is host vlan network) network 192.168.1.0 (this is the GE0/0 network) neighbor 192.168.1.1 (this is router 1 GE interface) interface vlan 10 ip address 192.168.10.1 255.255.255.0 (I can ping this from router 1) Thanks for any help you might be able to provide.
Everyone's tags (1)
11
Views
0
Helpful
0
Replies
CreatePlease login to create content