hello below is my configuration for my router. I have enabled ip routing as well and rebooted my router.
Here is what I can do.
1) I can ping the 10.0.33.x network from the 192.168.123.x network
2) I can get out to the internet using 192.168.123.x network VIA fa 0/2/0
What I CAN NOT do
1) get out to the internet from 10.0.33.x network. using GW 192.168.123.253?
2) also is it possible to somehow keep this config and route my 10.0.33.x network out int fa 0/0.34 if I put it on a sub interface?
!
interface FastEthernet0/0
no ip address
duplex auto
speed auto
!
interface FastEthernet0/1
no ip address
duplex auto
speed auto
!
interface FastEthernet0/2/0
description to firewall
switchport access vlan 123
no ip address
!
interface FastEthernet0/2/1
description to PC Netowrk 2960 switch fa 47
switchport access vlan 123
no ip address
duplex full
speed 100
!
interface FastEthernet0/2/2
description to PC Network 2960 switch fa 48
switchport access vlan 123
no ip address
duplex full
speed 100
!
interface FastEthernet0/2/3
description to server network
switchport access vlan 33
no ip address
duplex full
speed 100
!
interface Vlan1
no ip address
!
interface Vlan33
description server network
ip address 10.0.33.2 255.255.255.0
no ip-redirects
!
interface Vlan123
description PC network
ip address 192.168.123.1 255.255.255.0
no ip-redirects
!
router ospf 100
log-adjacency-changes
network 10.0.33.0 0.0.0.255 area 0
network 192.168.123.0 0.0.0.255 area 0
!
ip classless
ip route 0.0.0.0 0.0.0.0 192.168.123.253
ip http server
!
!
access-list 101 permit icmp any any
access-list 101 permit icmp any any echo
access-list 101 permit icmp any any echo-reply
access-list 101 permit icmp any any source-quench
!
control-plane
!
!
line con 0
line aux 0
line vty 0 4
login
!
scheduler allocate 20000 1000
!
