Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

routing using eigrp

Hi all, I was reading some info on eigrp with the auto summary command switched on, If I have say 5 routers say on 10.1/16 10.2/16 10.3/16 10.4/16 and 10.5/16 each connected via an ethernet port in the 192.168.1.0/30 range, will they see each other with the correct mask or will it auto summarize them to a 10 network and so will not work ?

1 REPLY

Re: routing using eigrp

It will summarise, and thus not work properly.

Paul.

119
Views
3
Helpful
1
Replies
CreatePlease to create content