Hello, I am new to Cisco routers and I have a 2801 unit here I would like to setup for static routing. I have two firewalls, both Watchguard x core units. One is configured on a DSL connection, the other on cable. I want to route all traffic destined for 10.60.0.0 network through firewall A on the DSL, while all other traffic is routed through firewall B on the cable connection. Is this possible with the 2801 and where is a good place to start learning how to configure it to do so? Thanks!!!
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...