Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RPR

Hi!

on 4507r,2 sup:sup-wsx4515;i need to configure the RPR Mode;do i need to put the console into sup on slot 2 and configure the redandany mode(rpr) or it is done in the 1st sup on the slot 1 if all config its done form there.

10xs

5 REPLIES
Cisco Employee

Re: RPR

Hi Ali,

This will help you in configuring RPR on 4507R

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_12/config/rpr.htm#wp1097801

Supervisor engine redundancy is configured by default when a second supervisor engine is detected

Do read the section "Supervisor Engine Redundancy Guidelines and Restrictions"

HTH

Ankur

New Member

Re: RPR

Hi Ankur!

Thanks a lot for ur reply.

Ali

Re: RPR

Cisco Employee

Re: RPR

Hi Devang,

Long time!! How are you!!

I believe what Ali is looking for is RPR operation betwen 2 supervisor engines which is route processor redundancy.

Regards,

Ankur

New Member

Re: RPR

Hello Devang!

Welcome Back;long Time Ya man;where have you been?

Ali

134
Views
10
Helpful
5
Replies
CreatePlease to create content