The Cisco Catalyst 3750 v2 Series Switches are capable of reverting to their internal power supply without any service interruption. In addition, the Cisco RPS 2300 can be managed by a Cisco Catalyst 3750 v2 Series Switch that is connected to it.
In the release notes of the rps 2300 it states that a reload could occur, and that only the 3750-E will have no service interruption. Anyone have any updates on this?
did you get anywhere with your question, the reason I ask I that I have connected an RPS2300 to a 3750V2 and when I pull the mains input there is a short break in traffic flow. The unit doesnt reboot but seems the hardware switching fabric maybe stops for 1-2 seconds. This is a big problem for me.
Is there a specific piece of config which needs to be looked at, all I have is a single RPS feeding a single 3750v2. All of the configurations are default.
Any help appreciated as this seems to be far from seamless as stated in the documentation.
There were many small enhancements made on the V2 3560/3750's. One such change is how the internal power supply/RPS fails over during a failure, it is now possible in the 3750v2's to fail back to the internal power supply. This enhancement was "borrowed" from how this works on the 3750-E.
thanks for the reply. I appreciate what the documentation says, however this doesnt seem to work in practice! Are there any specific settings to permit this? Whats wrong with a good old fasioned diode 'OR' arrangement at the DC level!!?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...