I have a 2921 with a RPS-Adptr-2921-51 installed and connected to a RPS 2300.
I plugged the router and RPS to 2 different circuits, the router powers up but when I pull the power to the internal power supply of the router, it powers down and doesnt return even with the RPS powered on.
I also notice the "RPS" indicator light on the RPS-Adptr-2921-51 is not lit.
This router is the only device connected to the RPS.
powered both units off plugged in the 2921 to rps plugged in rps to power (left internal power of 2921 unplugged) waited 1 minute, rps and router powered on a minute after that, rps stayed on, router powered off
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...