I have a 2921 with a RPS-Adptr-2921-51 installed and connected to a RPS 2300.
I plugged the router and RPS to 2 different circuits, the router powers up but when I pull the power to the internal power supply of the router, it powers down and doesnt return even with the RPS powered on.
I also notice the "RPS" indicator light on the RPS-Adptr-2921-51 is not lit.
This router is the only device connected to the RPS.
powered both units off plugged in the 2921 to rps plugged in rps to power (left internal power of 2921 unplugged) waited 1 minute, rps and router powered on a minute after that, rps stayed on, router powered off
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.