Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RPS 2300 with Catalst 3750 series 48 Switch behavior

I have an environment with serveral 3750 with RPS C3K-PWR-750WAC Suplying redundant power. recently several of these switch rebooted and recovered. The rps did not appear to go down. on the switch a SHOW ENV ALL is showing SYS PWR as BAD. RPS led is amber. I so far found that the only way to clear this status is to disconnect the the cable from the RPS to the back of the switch. THis clears the message. But is there a way I can clear it from the IOS without having to physically touch the device.

1 REPLY
Purple

Re: RPS 2300 with Catalst 3750 series 48 Switch behavior

I don't think so if its a plain 3750 and not a 3750E .

236
Views
0
Helpful
1
Replies