Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RPS and management software

Hi!

I read RPS 675 manual who cames with RPS equipment.

In that, read the folowing sentence:

"the RPS 675 sends status information to the other conected devices and to network management software"

How i can notify an snmp or something else that RPS is active providing power supply on a switch power failure? RPS does't have an interface, doen't have an ethernet or any other connections with my network.

The switch who are using RPS notify?

What show command can tell me in a remote connection that RPS is in use?

my native language is portuguese and my english is poor.

regards,

alex

1 REPLY
Silver

Re: RPS and management software

Use this document it provides information on how to monitor the status of the RPS in those switches using SNMP.

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080204461.shtml

169
Views
5
Helpful
1
Replies