We are going to configure some new switches with Cisco Redund Pwr System 2300 No PSU.
We have received all the switches but not the Cisco Redund Pwr System 2300 No PSU.
Can I go ahead and configure the switches without the Cisco Redund Pwr System 2300 No PSU.
And then when the Cisco Redund Pwr System 2300 No PSU arrives, will I need to shut down the switches in order to configure them for the inclusion of the Cisco Redund Pwr System 2300 No PSU.
Another instance is that we may receive the Cisco Redund Pwr System 2300 No PSU but not the CATALYST 3750-E/3560-E/RPS 2300ACCS, CAB-RPS2300= Spare RPS2300 cables to connect the switches, can I go ahead and configure for the Cisco Redund Pwr System 2300 No PSU and then later add the cables to the switches when they arrive. Will I have to power down the switches as they may likely be in production by then?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...