Has anyone connected an RS-422 interface with a Mil-STD-188/114 interface. Wikipedia (http://en.wikipedia.org/wiki/EIA-422 - 6th paragraph) and the Mil Std website (http://milstd.net/mil-std-188.htm) says that these two interfaces can interoperate despite there being a different voltage range! Does anyone know or have an opinion as to whether these two interfaces can interconnect? I'm concerned about short circuiting one or the other interface due to the different voltage range?
The document says that EIA-422 can interoperate with interfaces designed to MIL-STD-188-114B, but they are not identical. EIA-422 uses a nominal 0 to 5 Volt signal while MIL-STD-188-114B uses a signal symmetric about 0 V. However the tolerance for common mode voltage in both specifications allows them to interoperate. Care must be taken with the termination network. Mean care must be taken during the connecting those interface
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.