I am having a little issue with RSpan, well actually I am having a little issue with me. Specifically my lack of understanding. I have read several How to's and am pretty sure I am more confused than when I started.
Here is what I am trying to do.
I want the source to be all traffic on VLAN 65 on Switch A and Switch B. I want the destination to be port g2/21 on Switch B.
Currently I have the following config on Switch B and it works fine on Switch B.
monitor session 1 source vlan 65
monitor session 1 destination interface Gi2/21
I have remvoed all of the commands from Switch A. All the monitoring ones at least.
I am not sure what I need to do to Switch A and what else, if nessesary, to switch B.
Hope that makes sense to someone. Thanks in advance for the help.
If switch A is connected via a trunk to switch B, you can only use RSPAN on switch B to get the traffic to switch A. However you cannot mix SPAN and RSPAN to a single destination port! You will need a separate interface for this.
Your monitor session on switch B is actually a (local) SPAN session.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.