Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RSPAN Config Mulitple Switches

Hello,

Quick answer from you fellas.

Switch A - 6509 - Sup720 - Advanced IP

Switch B - 3550 12G - Advanced IP

Switch C - 3550 12G - Advanced IP

Switch A has the sniffer on gi7/2 and 2 vlans I would like to monitor

Switch B has 1 Vlans I would like to monitor

Switch C has 1 Vlans I would like to monitor

Switch C connects to Switch B then Switch B Connects to Switch A.

Looking at the 3550 RSPAN I "think" i may have figure it out but am not quite sure and am a little Leary about placing this in production. Any ideas would be greatly appreciated!

B1Cisco3550 <SWITCH C>

!

vlan 901

remote span

name REMOTE_SPAN

!

monitor session 1 source vlan 101 rx

monitor session 1 desintation remote vlan 901 reflector-port gi0/10

!

int gi0/10

description UPLINK-B3CISCO3550-RSPAN-LINK

switchport trunk encapsulation dot1q

switchport mode trunk

switchport trunk allowed vlan 901

B3Cisco3550 <SWITCH B>

!

vlan 901

remote span

name REMOTE_SPAN

!

monitor session 1 source vlan 103 rx

monitor session 1 destination remote vlan 901 reflector-port gi0/9

!

int gi0/10

description UPLINK-B1CISCO3550-RSPAN-LINK

switchport trunk encapsulation dot1q

switchport mode trunk

switchport trunk allowed vlan 901

!

int gi0/9

description UPLINK-B5CISCO6509-RSPAN-LINK

switchport trunk encapsulation dot1q

switchport mode trunk

switchport trunk allowed vlan 901

B5Cisco6509 <SWITCH A>

!

vlan 901

remote span

name REMOTE_SPAN

!

vlan 105

name BUILDING_5_NET

!

vlan 117

name ENG_DEV_NET

!

monitor session 1 source remote vlan 901

monitor session 1 source vlan 105 rx

monitor session 1 source vlan 117 rx

monitor session 1 desination interface gi7/2

!

int gi0/9

description UPLINK-B3CISCO3550

switchport trunk encapsulation dot1q

switchport mode trunk

switchport trunk allowed vlan 901

1 REPLY
New Member

Re: RSPAN Config Mulitple Switches

Well I figured it out there are some mis-configs above. Like the 3550 you have to burn the reflector-port. Meaning you cannot use it. :)

119
Views
0
Helpful
1
Replies