Hello, I have an issue with RSPAN. It is possible to have 2 monitor source sessions each on a different switch through a single rspan vlan and one monitor destination on a third switch to a single port? All 3 switches are trunked together and transporting the rspan vlan.
Wireshark Ã ttached on the destination port shows both tx and rx of the left most switch, but only the tx stream of the switch in the middle. See attachment. Routers are voice gateways and the traffic is in- and outbound voice to Cisco IP Phones (not in the picture)
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...