Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RSPAN issue

Dear All,

I have 2 Catalyst 4507 trunked together, and already have an RSPAN session configured on them. The problem is I cannot see any traffic on the protocol analyzer attached to the destination port.

I've created rspan vlan 937 on both switches, and it is allowed on the trunk.

SW A:

monitor session 1 source interface Gi4/6
monitor session 1 filter packet-type good rx
monitor session 1 destination remote vlan 937

Session 1
---------
Type                   : Remote Source Session
Source Ports           :
    Both               : Gi4/6
Filter Pkt Type        :
    RX Only       : Good
Dest RSPAN VLAN        : 937

SW B:

monitor session 1 destination interface Gi3/43
monitor session 1 source remote vlan 937

Session 1
---------
Type                   : Remote Destination Session
Source RSPAN VLAN      : 937
Destination Ports      : Gi3/43
    Encapsulation      : Native
          Ingress      : Disabled
         Learning : Disabled
Filter Pkt Type        :
    RX Only       : Good

Destination port:

interface GigabitEthernet3/43
switchport trunk encapsulation dot1q
qos trust dscp
spanning-tree portfast trunk
spanning-tree bpduguard enable
service-policy input QOS-IN

Local session is working, I've tried, please advise

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: RSPAN issue

Hello Zoltanormos,

have you configured vlan 937 as a remote span vlan in vlan mode?

conf t

vlan 937

remote-span

this has to be done on both switches

remote-span command disables mac address learning

Hope to help

Giuseppe

2 REPLIES
Hall of Fame Super Silver

Re: RSPAN issue

Hello Zoltanormos,

have you configured vlan 937 as a remote span vlan in vlan mode?

conf t

vlan 937

remote-span

this has to be done on both switches

remote-span command disables mac address learning

Hope to help

Giuseppe

New Member

Re: RSPAN issue

That's it! Thanks

1068
Views
5
Helpful
2
Replies