Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

RSPAN

Hello I need to know how do to configure a second port to redundancy in RSPAN. I need to have 2 port destination in session monitor of rspan.

1 REPLY
Hall of Fame Super Silver

Re: RSPAN

Hello Santiago,

in global config you just need to specify a list of two ports in the destination command:

Router(config)# monitor session RSPAN_destination_session_number destination {single_interface | interface_list | interface_range | mixed_interface_list} [ingress [learning]]

see

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/configuration/guide/span.html#wp1020380

this is supported on C6500 with Sup720

Hope to help

Giuseppe

129
Views
0
Helpful
1
Replies
CreatePlease to create content