Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RSPAN

Hi All,

I have got a core Switch 6506 uplink in ether channel(gi1/1 and gi1/2). core is connected to the access switch port.

uplink-------Core6506-----------access3750-----------Monitoring server

I want to monitor the VOIP traffice on the different access switch.

Please let me know what are the commands i need to exicute to run the RAPAN in Core and the access switch.

Please helppppppp

1 REPLY
Cisco Employee

Re: RSPAN

First of all you have to create a vlan which will be only used for carrying the RSPAN traffic.Create a dedicated vlan on both the switches:

Conf t

vlan xx

remote-span

On the source switch i.e 6506 you have to run the following command:

conf t

monitor session 1 source < Define the interfaces or source vlan that you want to monitor>

monitor session 1 destination remote vlan xxx

On you destination switch i.e 3750:

conf t

monitor session 1 source vlan xxx

monitor session 1 destination interface fa X/x -> port connected to the monitoring server.

Please use the link below for more info:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/122sx/swcg/span.htm

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12235se/scg/swspan.htm

HTH,Please rate if it does.

-amit singh

105
Views
5
Helpful
1
Replies
CreatePlease login to create content