Do I have problems when I'm running on all the switches RSTP (see fig) ? CORE switches are 6500 connected via a channel, 3560 are stacked with yellow cable and one 3560 is connected via fiber to CORE1 and the other 3560 to CORE2
There should be no problem running rpvst . The 3560's are not stacked , they don't have a stack cable like the 3750's do . They are probably using a sfp gbic cable to daisy chain the switches together .
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...