Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

running config could notbe copied to startup config of your router

Hi, I have a Cisco 857W and I'm using the SDM to configure but whenever I try and save my changes to the router I get the error message that 'running config could notbe copied to startup config of your router'

ANy suggestions

thanks

David

1 REPLY
Bronze

Re: running config could notbe copied to startup config of your

Perform the following commands and then check for the issue.

Under Config Mode:

Router(config)#Ip http server

Router(config)#Ip http secure-server

Router(config)#Ip http authentication local

Under Line vty 0 4:

Router(config-line)#login local

Router(config-line)#transport input telnet ssh.

After configuring Re-launch SDM with http/https authentication and try

clicking the "save" button by making some changes using SDM.

Also check for device memory available.

104
Views
0
Helpful
1
Replies
CreatePlease to create content