06-07-2007 05:31 AM - edited 03-05-2019 04:33 PM
Have an ATA flash card that can not be formatted or read in slot0 of the 6509 sup2-2ge engine. Is there another card recommended for this?
Solved! Go to Solution.
06-07-2007 05:40 AM
Hi Friend,
From release notes
With software releases 7.5(1) and later, additional Flash PC card support was added as follows:
?64-MB ATA Flash PC card (MEM-C6K-ATA-1-64M=)?Only supported on Supervisor Engine 2. The device name is disk0: and the card requires ROMMON version 7.1(1) and later releases.
?64-MB linear Flash PC card (MEM-C6K-FLC64M=)?Only supported on Supervisor Engine 1. The device name is slot0: and the card requires ROMMON software release 5.3(1) and later releases.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/relnotes/ol_4498.htm#wp410962
HTH
Ankur
*Pls rate all helpfull post
06-07-2007 05:39 AM
You can use ATA flash card in Sup2 engine but make sure the ROMMON version is at 7.1(1)
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/cfgnotes/6507_01.htm
06-07-2007 06:10 AM
The ROMMON version is 7.1(1).
06-07-2007 05:40 AM
Hi Friend,
From release notes
With software releases 7.5(1) and later, additional Flash PC card support was added as follows:
?64-MB ATA Flash PC card (MEM-C6K-ATA-1-64M=)?Only supported on Supervisor Engine 2. The device name is disk0: and the card requires ROMMON version 7.1(1) and later releases.
?64-MB linear Flash PC card (MEM-C6K-FLC64M=)?Only supported on Supervisor Engine 1. The device name is slot0: and the card requires ROMMON software release 5.3(1) and later releases.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/relnotes/ol_4498.htm#wp410962
HTH
Ankur
*Pls rate all helpfull post
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: