I have an RV110W which has repeatedly presented the following symptoms.
I set it up as a DHCP server for its LAN ports. One of the LAN ports is connected to an SF302-08P switch. I then have a few hosts on the switch. I also enable the RV110W's WLAN. All the ports (LAN, WLAN) are in VLAN 1.
Every host is able to obtain a DHCP scope from the RV110W, whether on LAN or WiFi.
Then, I select a list of the DHCP leases, and assign them as DHCP reservations.
After some time (unknown trigger or duration to wait for trigger), the hosts that are part of the DHCP reservations are not able to obtain DHCP scope renewals, nor are they able to obtain new DHCP scopes (post-reboot). All hosts eventually self-assign a 169.x.x.x address.
A router re-boot (power cycle) does nothing to alleviate the problem. I use a laptop connected via either WLAN or LAN, and it cannot obtain a DHCP scope. The SSID is up, and authentication (WPA2) still works.
I finally was able to manually address the laptop, connect in via WLAN, and was able to log into the router. From there, I selected and deleted all DHCP reservations. Then all begins to work again.
Have not determined if a *new* host, not part of the DHCP reservations, is able to get a new scope.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...