Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Same aggregate policer applied to different policy-map under different class

In Cisco 7600, I created a named aggregate policer: AGGRE. Then I call the same aggregate policer from 2 different policy-map (POLICE-2 and POLICE-3) using the police aggregate command. Note that in each policy-map, the aggregte policer is called under different class: CLASS-2 and CLASS-3. Finally I applied POLICE-2 and POLICE-3 to vlan 2 and vlan 3. Will the aggregate policer work on the aggregation of traffic from both VLAN 2 and 3? Or will it just work independantly on either vlan?

mls qos aggregate-policer AGGRE ...

class CLASS-2

match access-group ACL2

class CLASS-3

match access-group ACL3

policy-map POLICE-2

  class CLASS-2

  police aggregate AGGRE

policy-map POLICE-3

  class CLASS-3
  police aggregate AGGRE


interface Vlan2
service-policy output POLICE-2

interface Vlan3
service-policy output POLICE-3

879
Views
0
Helpful
0
Replies