In Cisco 7600, I created a named aggregate policer: AGGRE. Then I call the same aggregate policer from 2 different policy-map (POLICE-2 and POLICE-3) using the police aggregate command. Note that in each policy-map, the aggregte policer is called under different class: CLASS-2 and CLASS-3. Finally I applied POLICE-2 and POLICE-3 to vlan 2 and vlan 3. Will the aggregate policer work on the aggregation of traffic from both VLAN 2 and 3? Or will it just work independantly on either vlan?
mls qos aggregate-policer AGGRE ...
class CLASS-2
match access-group ACL2
class CLASS-3
match access-group ACL3
policy-map POLICE-2
class CLASS-2
police aggregate AGGRE
policy-map POLICE-3
class CLASS-3
police aggregate AGGRE
interface Vlan2
service-policy output POLICE-2
interface Vlan3
service-policy output POLICE-3