SDM 2.5 Easy VPN - "Unnumbered to new loopback interface"
I guess I've never seen this option before today. Prior you simply selected your external interface for configuring Easy VPN. However, now it states "A virtual template interface must be unnumbered to a router interface to obtain an IP address."
This is really throwing me for a loop [no pun intended]. Why do you have set a loopback interface for remote access VPN? I've done this before from the CLI. First the ISAKMP policy. Then the ISAKMP Client Config. Then the transform set. Next the dynamic-map. Then the user accounts and aaa authentication/authorization setting.
I'm just not understanding how a VTI plays into it? Does it have to be in the same subnet as your ip pool? I've read my ISCW book and looked online and I'm really not understanding what to configure, how to configure it, and esp. why to configure "an unnumbered virtual template interface to a router interface to obtain an IP address."
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...