while i configured SSH on my switch and with username and password privelege 15 accessing , but still i cannot open the SDM for the switch , when i try to login and write username and password and enter , it shows me again to login
CCP has completely replaced CNA. I deal with CCP on a daily basis and hate it with a passion. But, for people that are not that familiar with the CLI, it's a good tool. The ISR G2 routers come with a default DHCP Pool, so you should be able to connect a network cable from your laptop to the router, get an IP address, and connect to the router.
You will need to change the default cisco/cisco login/password, because if you don't and reboot, you can only use that login/pass combo once, and will have to password reset your router.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...