A operator did some configuration on the switch, added route-maps on a policy already enable on an interface and suddenly the trafic didn't processed anymore. He restored the old configuration on the startup config and reboot the device.
When the device became up again, I noticed that de sdm prefer changed!! It was in the routing mode and it changed by its own on desktop default....
Did anyone already met this behaviour? Is there any issue with the pbr process? Do I need to replace de device?
The setting of SDM template is stored in special files inside the flash: filesystem (I believe it is the private-config.text), so if the operator was very thorough and began erasing the configuration and replacing it with a clean startup configuration, he might have caused the SDM to revert to the default value. Alternatively, his clean startup config may have contained a default SDM template setting.
At this point, I do not believe there is any cause for concern.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...