currently we have cat 6506 in our network with single SUP2
now we planned to put secondary SUP on the slot 2
once we inserted secondary SUP2 module with same IOS and model it went to STANDBY COLD state
we configured the primary SUP redunanacy mode as RPR+ and Same as Secondary
but why it says below details
why Operating Redundancy Mode = rpr
Redundant System Information :
------------------------------
Available system uptime = 15 weeks, 5 days, 16 hours, 3 minutes
Switchovers system experienced = 0
Standby failures = 1
Last switchover reason = none
Hardware Mode = Duplex
Configured Redundancy Mode = rpr-plus
Operating Redundancy Mode = rpr
Maintenance Mode = Disabled
Communications = Up
Current Processor Information :
-------------------------------
Active Location = slot 1
Current Software state = ACTIVE
Uptime in current state = 15 weeks, 5 days, 16 hours, 3 minutes
Image Version = Cisco Internetwork Operating System Software
IOS (tm) s222_rp Software (s222_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(18)SXF10
a, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled Wed 19-Sep-07 12:15 by kellythw
BOOT = ,1;disk0:s222-advipservicesk9_wan-mz.122-18.SXF
10a.bin,1;
BOOTLDR = bootflash:c6msfc2-boot-mz.121-8a.EX
Configuration register = 0x2102
Peer Processor Information :
----------------------------
Standby Location = slot 2
Current Software state = STANDBY COLD
Uptime in current state = 12 hours, 46 minutes
Image Version = Cisco Internetwork Operating System Software
IOS (tm) s222_rp Software (s222_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(18)SXF10
, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled Fri 13-Jul-07 02:59 by kellythw
BOOT = ,1;disk0:s222-advipservicesk9_wan-mz.122-18.SXF
10a.bin,1;
BOOTLDR = bootflash:c6msfc2-boot-mz.121-8a.EX
Configuration register = 0x2102
