09-23-2008 09:51 AM - edited 03-06-2019 01:32 AM
Hello,
I am wondering if there is an equivalent command of mac-address-table secure for Cisco 800 series.
The point is that I would like to connect some specific machines (with specific MAC address obviously) to an interface of my router. I would like also to put the maximum secure addresses (Not sure if it is possible as there is in Catalyst)
You help is most appreciated.
Mehdi
09-23-2008 10:36 AM
Mehdi
These restrictions are supported on the switches but not on IOS routers. So it is not possible to do these on the 800 series routers.
HTH
Rick
09-23-2008 12:42 PM
Thanks for your help Rick.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide