Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Secure Addresses on Interface Cisco 800 series

Hello,

I am wondering if there is an equivalent command of mac-address-table secure for Cisco 800 series.

The point is that I would like to connect some specific machines (with specific MAC address obviously) to an interface of my router. I would like also to put the maximum secure addresses (Not sure if it is possible as there is in Catalyst)

You help is most appreciated.

Mehdi

2 REPLIES
Hall of Fame Super Gold

Re: Secure Addresses on Interface Cisco 800 series

Mehdi

These restrictions are supported on the switches but not on IOS routers. So it is not possible to do these on the 800 series routers.

HTH

Rick

Community Member

Re: Secure Addresses on Interface Cisco 800 series

Thanks for your help Rick.

364
Views
3
Helpful
2
Replies
CreatePlease to create content