securing the clients of cisco 851 through the wired lan ports
I am needing to configure the following command in a cisco 851:
cisco 851 mac-address-table secure
The cisco has the following version: "flash:c850-advsecurityk9-mz.124-15.T4.bin"
Cisco 851 (MPC8272) processor (revision 0x200) with 59392K/6144K bytes of memory. Processor board ID FHK121623WA MPC8272 CPU Rev: Part Number 0xC, Mask Number 0x10 5 FastEthernet interfaces 128K bytes of non-volatile configuration memory. 20480K bytes of processor board System flash (Intel Strataflash)
I had read in the site of cisco that this routers accepts the mac security feature but that command is not accepted by the router.
In resume I need to secure the router permiting only the trusted clients and denying the other possible clients through the wired lan ports
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.