Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

security problems or how to enable telnet and http access

Another questin, after getting installed of new SDM (2.5) ver, it has changed a security policy. i started setup utility, and this thing told me that HTTP and TELNET are disabled, i tried to enter 'ip http enable' and so on, it doesnt give me an ability to get connected to the terminal via telnet, sdm web configurator also doesnt work, the only way to get connected is to use rs232 interface only. is there a way to turn off that security preset for having an ability to use telnet or http in normal way via ethernet interface? please help me :(

1 ACCEPTED SOLUTION

Accepted Solutions

Re: security problems or how to enable telnet and http access

Hi,

There is access-list 23 which is restricting your access

disable the access-list using the following commands :

no ip http access-class 23

line vty 0 4

no access-class 23 in

Hope this helps.

4 REPLIES

Re: security problems or how to enable telnet and http access

please post the running-config.

Community Member

Re: security problems or how to enable telnet and http access

it is in attach

Re: security problems or how to enable telnet and http access

Hi,

There is access-list 23 which is restricting your access

disable the access-list using the following commands :

no ip http access-class 23

line vty 0 4

no access-class 23 in

Hope this helps.

Community Member

Re: security problems or how to enable telnet and http access

WOW! Man, I LOVE YOU!! Many thanks!

189
Views
0
Helpful
4
Replies
CreatePlease to create content