Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Seperating Traffic & VLANs

I have a 1841 router connected to the Internet. Connected to the 1841 is a stack of 2960 switches. I have 5 VLANs on my switches and am using sub interfaces on the 1841. I have a public range of IP addresses. I want one of my VLANs to be the public range. If I need a port on that VLAN I will just configure the port on the right VLAN. I am not sure how to configure this? For security I don't want any of this traffic to be routed between the VLANs. I want it completely isolate. Does anyone have any suggestions. Thanks

2 REPLIES
Silver

Re: Seperating Traffic & VLANs

Hi,

You can use access list to block the traffic from other Vlans by binding it to sub-interface.

HTH

Saju

Pls rate helpful posts

Re: Seperating Traffic & VLANs

Why are you putting your public addresses on a VLAN? I'd use your VLANs for only internal connections, and then use FA0 or FA1 for your public addresses. If you need to have a range assigned, create a pool and do one-to-one NAT.

--John

HTH, John *** Please rate all useful posts ***
117
Views
0
Helpful
2
Replies