Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Sequestering traffic on a router-enabled port

Is there a way to use the "no switchport command to enable routing on a port and yet sequester it from traffic on other vlans within the switch?

The switch in question is a 3750E

2 REPLIES
Cisco Employee

Sequestering traffic on a router-enabled port

The port can be placed into a vrf and would be isolated from the routing table on the switch.

- Dan

Purple

Sequestering traffic on a router-enabled port

Hi,

You can also create a RACL  and apply it on this port.

Regards.

Alain

Don't forget to rate helpful posts.
164
Views
0
Helpful
2
Replies
CreatePlease login to create content