Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Serial0/1/0 is up, line protocol is down (disabled)

Hi,

I just connected my two routers with serial interfaces but they're unable to communicate. And sh int serial 0/1/0 is showing like that.

Here the output from one of the routers:

Router1#show interfaces se

Router1#show interfaces serial 0/1/0

Serial0/1/0 is up, line protocol is down (disabled)

  Hardware is HD64570

  Internet address is 11.0.0.2/30

  MTU 1500 bytes, BW 128 Kbit, DLY 20000 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation HDLC, loopback not set, keepalive set (10 sec)

  Last input never, output never, output hang never

  Last clearing of "show interface" counters never

  Input queue: 0/75/0 (size/max/drops); Total output drops: 0

  Queueing strategy: weighted fair

  Output queue: 0/1000/64/0 (size/max total/threshold/drops)

     Conversations  0/0/256 (active/max active/max total)

     Reserved Conversations 0/0 (allocated/max allocated)

     Available Bandwidth 96 kilobits/sec

  5 minute input rate 0 bits/sec, 0 packets/sec

  5 minute output rate 0 bits/sec, 0 packets/sec

     0 packets input, 0 bytes, 0 no buffer

     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

     0 packets output, 0 bytes, 0 underruns

     0 output errors, 0 collisions, 1 interface resets

     0 output buffer failures, 0 output buffers swapped out

     0 carrier transitions

     DCD=up  DSR=up  DTR=up  RTS=up  CTS=up

Router1#

Please help me out of this.

Regards,

Chandu

Regards, Chandu
Everyone's tags (1)
768
Views
0
Helpful
0
Replies
CreatePlease to create content