12-09-2007 08:01 PM - edited 03-05-2019 07:53 PM
Guys i have a server and i want to do teaming..........i have two switches 3750 one.....can someone please send me a sample config how to do that.......regards
12-09-2007 08:14 PM
Hi, refer to link bellow, you need etherchannel configuration, you cannot do teaming and etherchannel across different switches as it is not possible but can do it in a single switch.
http://www.cisco.com/en/US/tech/tk389/tk213/technologies_configuration_example09186a008089a821.shtml
HTH
Jorge
rate post if it helps
12-10-2007 09:48 PM
Hi,
Iam having one doubt on the same.I am having two 3750 L3 switches which are configured in HSRP.
On 1 Vlan all my servers are conencted.For teaming servers I had connected another switch,assigning same VLAN and connected to the other giga port in 3750.
Is there any configuration need to be done for load sharing.
regds
Nasheer
12-10-2007 10:29 PM
Hi Nasher, you may want to look into other options like GLBP that offers hsrp functionality and load balancing .
http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cg/hiap_c/ch20/haipglbp.htm
Rgds
Jorge
12-11-2007 07:26 AM
Jorge,
I believe he is looking for teaming (etherchanneling) solution on the switch side, not 'next-hop redundancy'.
I addressed his question in the WAN forum.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: