Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

set port security 3/1 enable

A question to the community. Why not block a port with CATos  if enabled the Port-Security with maximum 1 and if they violate the policy goes, it can be error or version that is the problem.

In these ports connect more than two computers and not off the port on a 6500 Switch

Can you help me solve this problem

The vesion is cat6000-sup32pfc3k9.8-7-2a.bin

used commands are:

SW (enable) set port security 3 / 1 enable

SW (enable) set port security 3 / 1 maximum 1

SW (enable) set port security 3 / 1 violation shutdown

Thanks for the help 

1 REPLY

Re: set port security 3/1 enable

A question to the community. Why not block a port with CATos  if enabled the Port-Security with maximum 1 and if they violate the policy goes, it can be error or version that is the problem.

In these ports connect more than two computers and not off the port on a 6500 Switch

Can you help me solve this problem

The vesion is cat6000-sup32pfc3k9.8-7-2a.bin

used commands are:

SW (enable) set port security 3 / 1 enable

SW (enable) set port security 3 / 1 maximum 1

SW (enable) set port security 3 / 1 violation shutdown

Thanks for the help 

Hi,

Voilation shutdown will block /shutdown the port if it gets voilated for mentioned amount of time if specifed,Like variable that specify the duration for which a port will remain disabled in case of a security violation; valid values are 0 (to disable) and from 1 to 1440 (minutes).

So if voilation shutdown can bring down the port !!

Hope to Help !!

Ganesh.H

239
Views
0
Helpful
1
Replies
CreatePlease to create content