Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

set spantree bpduguard command

hi all,

on Catos switch  what does command   

sey spantree bpdu-guard 6/1-48 default mean?

my understanding is that it enables bpdu-guard globally on the module 6?

please let me know

thanks

mahesh

2 ACCEPTED SOLUTIONS

Accepted Solutions
VIP Super Bronze

Re: set spantree bpduguard command

Hi,

Yes, it would enable it on all ports on module 6.  You can also enable it globally (see below command) for all modules. It is disabled by default.

set spantree portfast bpdu-guard enable

Have a look at this doc for more info:

http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a008009482f.shtml

HTH

Reza

Re: set spantree bpduguard command

hi all,

on Catos switch  what does command   

sey spantree bpdu-guard 6/1-48 default mean?

my understanding is that it enables bpdu-guard globally on the module 6?

please let me know

thanks

mahesh

Hi Mahesh,

set spantree bpdu-guard mod/port {enable | disable | default} ,If you enter the default keyword, the spanning tree port is set to the BPDU guard state globally.To enable or disable BPDU guard for all ports on the switch, enter the set spantree global-default bpdu-guard command.

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

2 REPLIES
VIP Super Bronze

Re: set spantree bpduguard command

Hi,

Yes, it would enable it on all ports on module 6.  You can also enable it globally (see below command) for all modules. It is disabled by default.

set spantree portfast bpdu-guard enable

Have a look at this doc for more info:

http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a008009482f.shtml

HTH

Reza

Re: set spantree bpduguard command

hi all,

on Catos switch  what does command   

sey spantree bpdu-guard 6/1-48 default mean?

my understanding is that it enables bpdu-guard globally on the module 6?

please let me know

thanks

mahesh

Hi Mahesh,

set spantree bpdu-guard mod/port {enable | disable | default} ,If you enter the default keyword, the spanning tree port is set to the BPDU guard state globally.To enable or disable BPDU guard for all ports on the switch, enter the set spantree global-default bpdu-guard command.

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

805
Views
0
Helpful
2
Replies
CreatePlease to create content