Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Setting Static IP for PPOA on 857 using SDM

If I try and change the IP address on the dialer/atm interface using SDM from Negotiated to Fixed I get 'enter a valid IP address/subnet'. The address I am entering is that which is negotiated and I use a mask of 255.255.255.255.

If I try to set the address using telnet I get a similar result.

Can anyone help?

2 REPLIES
Silver

Re: Setting Static IP for PPOA on 857 using SDM

Remove all configuration for the dialer/atm interface and then put the address for the same interface. If possible try to create a new dialer interface and put the address. Also make sure that this address is not conflicting with any other address which is already configured. Also both the end points should have address in same network.

New Member

Re: Setting Static IP for PPOA on 857 using SDM

Many thanks, I will have to try this when I next get down to the site. We are remote from it and I do not want to change the dialer config too much remotely.

113
Views
0
Helpful
2
Replies