Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Setting up a Router & Switch for internet access

Hi all,

I need help setting up internet access on my cisco router.

It's a Cisco 2600, this is the setup.

I have a Cisco 3560 switch, and 5 clients connects to this switch.

I have one vlan defined VLAN 5.

I have a trunk port between the router and the switch.

My question is how to setup internet access between my switch and router?

Please if you can send config commands? I am not that fimiliar with router setup.

I know I need to setup a routing protocol, but need to know the command for that.

1 REPLY
Purple

Setting up a Router & Switch for internet access

Hi,

You need to nat on the 2600 router and you need a default route on the router.

How is router connected to WAN ?

Have you got multiple vlans on the switch? Is the switch doing routing or is it Layer2 ?

Post your config so that we can give you the missing commands

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
177
Views
0
Helpful
1
Replies
CreatePlease to create content