Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

setting up an EtherChannel

I setup a EtherChannel trunk, now i want to monitor/test this trunk what commands can i use to do the above?

thanks

rob davis

1 REPLY
Bronze

Re: setting up an EtherChannel

For monitoring there is show interfaces port-channel which verifies the EtherChannel configuration on the Cisco CMTS for the selected EtherChannel group. An example is here:

Router# show interfaces port-channel 1

Port-channel1 is up, line protocol is up

Hardware is FEChannel, address is 0000.0ca8.6220 (bia 0000.0000.0000)

MTU 1500 bytes, BW 400000 Kbit, DLY 100 usec, rely 255/255, load 1/255

Encapsulation ARPA, loopback not set, keepalive not set, fdx

ARP type: ARPA, ARP Timeout 04:00:00

No. of active members in this channel: 4

Member 0 : Fast Ethernet1/0/0

Member 1 : Fast Ethernet1/1/0

Member 2 : Fast Ethernet4/0/0

Member 3 : Fast Ethernet4/1/0

Last input 01:22:13, output never, output hang never

Last clearing of "show interface" counters never

Queueing strategy: fifo

Output queue 0/40, 0 drops; input queue 0/75, 0 drops

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

223 packets input, 11462 bytes, 0 no buffer

Received 1 broadcasts, 0 runts, 0 giants

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

0 watchdog, 0 multicast

0 input packets with dribble condition detected

192 packets output, 13232 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out

265
Views
0
Helpful
1
Replies