Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Setting up LAN extension

Hi,

For setting up a LAN extension between 2 geographicaly dispersed 6500 switches, the only configuration needed is VLAN trunk right? No need for channel group if I'm only using 1 copper link?

SW1

interface GigabitEthernet12/42

description LAN EXTENSION

switchport

switchport trunk encapsulation dot1q

switchport mode trunk

no ip address

end

SW2

interface GigabitEthernet12/42

description LAN EXTENSION

switchport

switchport trunk encapsulation dot1q

switchport mode trunk

no ip address

end

I want all VLAN's to be passed so I wont specify the allowed vlans...

Am I correct? Or am I missing something?

1 REPLY
Hall of Fame Super Bronze

Re: Setting up LAN extension

You aren't missing anything, you are correct in all counts. Good luck !

__

Edison.

231
Views
0
Helpful
1
Replies
CreatePlease to create content