I am configuring my Cisco 3560 for a Mitel 3300 ICP. I have attached a copy of my config files on the switch. I am new to setting up the mittel 3330. The documentation state I should set up my switch with the following guidelines:To simplify the installation and
use some pre-packaged commands, such as auto-qos, a COS value of 5 is recommended
throughout the network. Other values, such as 6, can still be used, but will require additional
tuning of the configuration at different ports.
In order to make the QoS settings work, the following points need to be considered:
" QoS must be enabled for the entire switch.
" The default COS and DSCP settings of the switch may not be those needed for voice.
" Settings that are needed include:
- Change mapping COS 5 to DSCP of 46 (Expedited Forwarding (EF) setting).
- Ensure that COS 5 is mapped to the EF queue.
- Enable the EF queue.
- Trust incoming ports based on COS value for end points, phones, 3300 ICP and voice
- PC phones may require DSCP remapping as well as DSCP to COS conversion.
- Enable CDP.
" Auto-qos trust will change a number of these settings.
" Some additional tuning may be needed to the settings to get full operation
I want to ensure the settings are accurate on my switch. I have attached my configs
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...