Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Setting Vlan1 to no ip address???

I have an BladeCenter switch that I need to remove the ip address from. When I try the no ip address cmd, I get an error message that says vlan 1 cannot be removed. We use "out-of-band" management on vlan 211 instead. Any ideas ?

Thank you!

3 REPLIES

Re: Setting Vlan1 to no ip address???

Hi,

The normal VLAN 1 can never be removed.

if there is an IP address on the VLAN 1 you need to go to:

#interface vlan 1

#no ip address

Otherwise you need to do

#no interface vlan 1

If you find this post usefull

please don't forget to rate this

#########################################

#Iwan Hoogendoorn

#########################################

New Member

Re: Setting Vlan1 to no ip address???

Could u copy paste the error to us?

I dont know if u already have the 211 Active and Working, or if u want to replace the management vlan on that switch.

Configure another ip reacheble on vlan 211, and then try to do the "management" command in the Vlan 211.

Vlan 1 should stay clear for remove ip address, i guess.

Dont realy remember if it works. If it the case, try it, and tell us how it works.

Petr?nio

Hall of Fame Super Blue

Re: Setting Vlan1 to no ip address???

Hi

As suggested by previous poster you need to configure vlan 211 and apply an IP address to that interface. Then you should be able to remove the address off vlan 1.

Is this what you have done ?

Jon

147
Views
0
Helpful
3
Replies